LABRepCo

This apliance is designed for the laboratory product storage so it is important to keep it clean. The equipment is thoroughly cleaned at the factory before being shipped. We recommend, however, to clean the interior cabinet before the first start up of the appliance. Before attempting any cleaning operation make sure the power cord is disconnected.

• Cleaning product: Use soft clean cloth wet with water and neutral detergent only. Do not use solvent or bleach.
• Rinsing: Use a cloth or sponge soaked with fresh clean water. Do not use water jet.
• Frequency: Once a week or at different intervals in accordance with the type of product. 

The condenser is a heat exchanger. If it is dirty or clogged the air cannot circulate freely through the same, it cannot discharge heat properly so reducing proportionally the performance and the efficiency of the refrigeration system. For those reasons it is important to keep clean the condenser coil, typically monthly.

• Always switch off the unit and disconnect power cord before cleaning, it is dangerous to do it with power ON: fan may start suddenly at any time.

Use a convenient ladder to reach the condenser. Use an air jet or vacuum with a soft dry brush if necessary and remove any dust or fluff from the heat exchanger fins. After cleaning, start the equipment.

• During the cleaning operation wear gloves and safety glasses to protect yourself from any injury.

Keep clean the sliding door housing to avoid the door can't close completely. Use a soft clean cloth or a soft brush in order to remove any residuals can block the door to slide in the full closure position. 

1. Cause: The main switch is "off."
   • Solution: Main switch "on."
2. Cause: There is no tension.
   • Solution: Check plug, socket, electric connection.
3. Cause: Other.
   • Solution: Contact technical assistance.

1. Cause: Set temperature is reached.
   • Solution: Set new temperature.
2. Cause: Defrosting is in operation.
   • Solution: Wait for end of cycle, switch off and switch back on.
3. Cause: Control panel is broken.
   • Solution: Contact technical assistance.
4. Cause: Other.
   • Solution: Contact technical assistance.

1. Cause: Room is too hot.
   • Solution: Air better.
2. Cause: Condenser is dirty.
   • Solution: Clean condenser.
3. Cause: Refrigerant fluid is insufficient.
   • Solution: Contact technical assistance.
4. Cause: Condenser fan has stopped.
   • Solution: Contact technical assistance.
5. Cause: Door not properly closed.
   • Solution: Check door seals.
6. Cause: Evaporator is frosted up.
   • Solution: Manual defrosting.
7. Cause: Defrost valve is open.
   • Solution: Contact technical assistance.

1. Cause: Control panel is broken.
   • Solution: Contact technical assistance.
2. Cause: Temperature probe is broken.
   • Solution: Contact technical assistance.
3. Cause: Door is not airtight.
   • Solution: Close door.

1. Cause: Improper Use.
   • Solution: Contact technical assistance.
2. Cause: Control panel is broken.
   • Solution: Contact technical assistance.

1. Cause: Appliance not leveled.
   • Solution: Check that appliance is level.
2. Cause: Contact with external bodies.
   • Solution: Check that no tube or ventilator fan is in contact with external bodies.
3. Cause: Screws or nuts loose.
   • Solution: Tighten.
4. Cause: Other.
   • Solution: Contact technical assistance.

1. Cause: Fan disconnected.
   • Solution: Re-wire the fan to the electrical strip contact.
2. Cause: Stuck fan.
   • Solution: Replace the fan.
3. Cause: Fan motor damaged.
   • Solution: Replace the fan.